In industrial packaging projects, plastic gears, bearings and wear parts is only acceptable when the paperwork is right. This article maps the standards, test methods and documents you should ask for.
Everything here can be checked on a real sample before you commit to a production order.
This category covers a family of products rather than a single item. In practice a buyer defines plastic gears, bearings and wear parts by three things: the base resin, the format or dimension, and the performance or certification level it has to meet. Typical options in this category include PTFE and oil filled compounds; module 0.3 to 8; bore tolerance H7 to H9. Materials most often specified are Polyamide, UHMWPE, Polyether Ether Ketone, Polytetrafluoroethylene, and the choice between them changes stiffness, temperature resistance, chemical behaviour and price.
In the industrial packaging sector the decision is usually driven by drop protection and cost per pack, with recyclability as a secondary requirement. Typical end uses include protective foam, bulk containers, strapping.
The table below summarises the values that usually decide the material choice.
| Material | Density | Tensile strength | Service temperature |
|---|---|---|---|
| Polyoxymethylene | 1.41 g/cm³ | 60-70 MPa | -40°C to 100°C |
| Glass Filled Nylon | 1.36-1.38 g/cm³ | 130-190 MPa | -40°C to 150°C |
| Polyamide | 1.13-1.15 g/cm³ | 60-85 MPa | -40°C to 120°C |
Polyoxymethylene is frequently the default selection here: POM is the standard replacement for small metal parts that must hold tight tolerances.
The following standards are the ones most often referenced in this product category.
Ask the supplier to state the standard number, the test method and the result on the certificate. A test report without a standard reference is difficult to defend during an audit.
Beyond the base resin, most suppliers offer UV stabilised, food contact, flame retardant, anti-static and recycled content versions of the same product. Ask which additive package is included, because it is often the difference between a part that lasts three years and one that lasts ten.
The route below is the one most factories use for this type of part.
Secondary operations such as printing, welding, machining and assembly are often cheaper to do in the same factory, and they reduce the risk of mismatch between components.
These are the criteria that actually predict whether the part will perform in service.
Send this list to your supplier with the drawing and you will receive comparable quotations from every factory you contact.
We can provide ISO 9001 quality system documentation, material certificates, RoHS and REACH statements, and where applicable food contact, flame retardancy or drinking water approvals. Tell us your target market and we will match the document set.
Standard packing is export cartons on fumigation-free pallets, with custom labelling, barcode and retail packing available. We also handle consolidated containers and door to door delivery.
For standard sizes and colours the minimum is usually one pallet or one production run; for custom tooling the economic minimum depends on the tooling cost amortised over the expected volume. Send us your annual volume and we will calculate the break even point.
Yes. {mat1} is one of our regular materials for this item, and we can supply virgin, modified and certified grades with full traceability. Material certificates and test reports are issued per batch.
Yes. Standard samples are normally free of charge and shipped within three working days; custom samples are charged at cost and credited against the first production order.
Our team supplies plastic gears, bearings and wear parts to industrial packaging customers worldwide, with samples, material certificates and full inspection reports available before mass production.
Rubber & Plastics © 2026 All Rights Reserved. Yingnet.com — Global B2B trade platform for rubber & plastics manufacturers.
About Us | Contact Us | Help Center | Sitemap