Recycled content rules, lightweighting and automation are reshaping how agriculture and horticulture buyers specify plastic extrusion profiles. Here is what is changing and how to prepare your sourcing plan.
Use it as a working checklist when you write your next enquiry.
This category covers a family of products rather than a single item. In practice a buyer defines plastic extrusion profiles by three things: the base resin, the format or dimension, and the performance or certification level it has to meet. Typical options in this category include cut lengths from 50 mm; co-extruded soft and hard zones; rigid, semi-rigid and flexible compounds. Materials most often specified are Polypropylene, Polyvinyl Chloride, High Density Polyethylene, Polycarbonate, and the choice between them changes stiffness, temperature resistance, chemical behaviour and price.
In the agriculture and horticulture sector the decision is usually driven by UV stabilisation and tear strength, with chemical resistance to fertilisers as a secondary requirement. Typical end uses include drip irrigation lines, silage wrap, greenhouse film.
These figures are typical for commercial grades and should be confirmed against the supplier's certificate for your specific lot.
| Material | Density | Tensile strength | Service temperature |
|---|---|---|---|
| Polycarbonate | 1.20 g/cm³ | 55-70 MPa | -40°C to 120°C |
| Acrylonitrile Butadiene Styrene | 1.04-1.06 g/cm³ | 30-50 MPa | -20°C to 80°C |
| Polypropylene | 0.90-0.91 g/cm³ | 25-40 MPa | -10°C to 100°C |
Polyvinyl Chloride is frequently the default selection here: PVC can be formulated from rigid pipe compound to soft medical grade by changing plasticiser content.
For buyers of plastic extrusion profiles, the practical response is to agree a specification that allows recycled content without sacrificing the mechanical properties, and to qualify a second source before capacity becomes tight.
Beyond the base resin, most suppliers offer UV stabilised, food contact, flame retardant, anti-static and recycled content versions of the same product. Ask which additive package is included, because it is often the difference between a part that lasts three years and one that lasts ten.
The route below is the one most factories use for this type of part.
Secondary operations such as printing, welding, machining and assembly are often cheaper to do in the same factory, and they reduce the risk of mismatch between components.
Use this checklist when comparing two or three supplier quotations.
Send this list to your supplier with the drawing and you will receive comparable quotations from every factory you contact.
A new tool typically takes 25 to 45 days depending on cavity count and complexity, followed by T1 samples within one week. Existing tools can usually start production within 10 to 15 days of order confirmation.
For standard sizes and colours the minimum is usually one pallet or one production run; for custom tooling the economic minimum depends on the tooling cost amortised over the expected volume. Send us your annual volume and we will calculate the break even point.
Yes. {mat1} is one of our regular materials for this item, and we can supply virgin, modified and certified grades with full traceability. Material certificates and test reports are issued per batch.
Yes. Standard samples are normally free of charge and shipped within three working days; custom samples are charged at cost and credited against the first production order.
Standard packing is export cartons on fumigation-free pallets, with custom labelling, barcode and retail packing available. We also handle consolidated containers and door to door delivery.
Share your specification and quantity with us and we will recommend the most cost effective material, tooling route and packing method for your market.
Rubber & Plastics © 2026 All Rights Reserved. Yingnet.com — Global B2B trade platform for rubber & plastics manufacturers.
About Us | Contact Us | Help Center | Sitemap