Energy and renewables buyers increasingly specify agricultural plastic products instead of metal, wood or glass. Here is where they are used, why they work, and what to watch out for.
Use it as a working checklist when you write your next enquiry.
This category covers a family of products rather than a single item. In practice a buyer defines agricultural plastic products by three things: the base resin, the format or dimension, and the performance or certification level it has to meet. Typical options in this category include mulch film 8 to 50 micron; greenhouse film 100 to 200 micron; drip line 16 mm with 0.2 L/h emitters. Materials most often specified are High Density Polyethylene, Ethylene Vinyl Acetate, Low Density Polyethylene, Polyvinyl Chloride, and the choice between them changes stiffness, temperature resistance, chemical behaviour and price.
In the energy and renewables sector the decision is usually driven by UV durability and flame retardancy, with electrical insulation as a secondary requirement. Typical end uses include wind blade components, solar junction boxes, insulating barriers.
These figures are typical for commercial grades and should be confirmed against the supplier's certificate for your specific lot.
| Material | Density | Tensile strength | Service temperature |
|---|---|---|---|
| Polyvinyl Chloride | 1.38-1.45 g/cm³ | 40-55 MPa | -10°C to 60°C |
| Low Density Polyethylene | 0.91-0.93 g/cm³ | 8-20 MPa | -50°C to 70°C |
| Ethylene Vinyl Acetate | 0.93-0.95 g/cm³ | 10-30 MPa | -40°C to 70°C |
Low Density Polyethylene is frequently the default selection here: LDPE is the workhorse of flexible packaging because of its softness and sealing behaviour.
The list below covers both high volume and specialised uses.
Beyond the base resin, most suppliers offer UV stabilised, food contact, flame retardant, anti-static and recycled content versions of the same product. Ask which additive package is included, because it is often the difference between a part that lasts three years and one that lasts ten.
The route below is the one most factories use for this type of part.
Secondary operations such as printing, welding, machining and assembly are often cheaper to do in the same factory, and they reduce the risk of mismatch between components.
Work through these points in order and most specification mistakes disappear.
Send this list to your supplier with the drawing and you will receive comparable quotations from every factory you contact.
Standard production tolerance follows the relevant ISO or DIN tolerance class for the process; tighter tolerances are possible after machining or grinding, but they add cost. Define the tolerance only on the functional dimensions.
Yes. {mat1} is one of our regular materials for this item, and we can supply virgin, modified and certified grades with full traceability. Material certificates and test reports are issued per batch.
Yes. Standard samples are normally free of charge and shipped within three working days; custom samples are charged at cost and credited against the first production order.
We can provide ISO 9001 quality system documentation, material certificates, RoHS and REACH statements, and where applicable food contact, flame retardancy or drinking water approvals. Tell us your target market and we will match the document set.
A new tool typically takes 25 to 45 days depending on cavity count and complexity, followed by T1 samples within one week. Existing tools can usually start production within 10 to 15 days of order confirmation.
Share your specification and quantity with us and we will recommend the most cost effective material, tooling route and packing method for your market.
Rubber & Plastics © 2026 All Rights Reserved. Yingnet.com — Global B2B trade platform for rubber & plastics manufacturers.
About Us | Contact Us | Help Center | Sitemap