In food and beverage projects, plastic gears, bearings and wear parts is only acceptable when the paperwork is right. This article maps the standards, test methods and documents you should ask for.
Use it as a working checklist when you write your next enquiry.
This category covers a family of products rather than a single item. In practice a buyer defines plastic gears, bearings and wear parts by three things: the base resin, the format or dimension, and the performance or certification level it has to meet. Typical options in this category include module 0.3 to 8; bore tolerance H7 to H9; PTFE and oil filled compounds. Materials most often specified are Polyamide, Polytetrafluoroethylene, Glass Filled Nylon, Polyoxymethylene, and the choice between them changes stiffness, temperature resistance, chemical behaviour and price.
In the food and beverage sector the decision is usually driven by food contact compliance and migration limits, with seal integrity as a secondary requirement. Typical end uses include shrink sleeves, bulk totes, takeaway trays.
These figures are typical for commercial grades and should be confirmed against the supplier's certificate for your specific lot.
| Material | Density | Tensile strength | Service temperature |
|---|---|---|---|
| UHMWPE | 0.93-0.94 g/cm³ | 30-45 MPa | -150°C to 80°C |
| Polyether Ether Ketone | 1.32 g/cm³ | 90-100 MPa | -50°C to 250°C |
| Polyoxymethylene | 1.41 g/cm³ | 60-70 MPa | -40°C to 100°C |
Polyoxymethylene is frequently the default selection here: POM is the standard replacement for small metal parts that must hold tight tolerances.
Paperwork matters as much as the part itself in regulated markets.
Ask the supplier to state the standard number, the test method and the result on the certificate. A test report without a standard reference is difficult to defend during an audit.
Beyond the base resin, most suppliers offer UV stabilised, food contact, flame retardant, anti-static and recycled content versions of the same product. Ask which additive package is included, because it is often the difference between a part that lasts three years and one that lasts ten.
The route below is the one most factories use for this type of part.
Secondary operations such as printing, welding, machining and assembly are often cheaper to do in the same factory, and they reduce the risk of mismatch between components.
These are the criteria that actually predict whether the part will perform in service.
Send this list to your supplier with the drawing and you will receive comparable quotations from every factory you contact.
Yes. {mat1} is one of our regular materials for this item, and we can supply virgin, modified and certified grades with full traceability. Material certificates and test reports are issued per batch.
Yes. Standard samples are normally free of charge and shipped within three working days; custom samples are charged at cost and credited against the first production order.
Colour is controlled with a masterbatch reference approved by the customer, and every production lot is checked against the approved sample under standard lighting before shipment.
Standard production tolerance follows the relevant ISO or DIN tolerance class for the process; tighter tolerances are possible after machining or grinding, but they add cost. Define the tolerance only on the functional dimensions.
A new tool typically takes 25 to 45 days depending on cavity count and complexity, followed by T1 samples within one week. Existing tools can usually start production within 10 to 15 days of order confirmation.
Share your specification and quantity with us and we will recommend the most cost effective material, tooling route and packing method for your market.
Rubber & Plastics © 2026 All Rights Reserved. Yingnet.com — Global B2B trade platform for rubber & plastics manufacturers.
About Us | Contact Us | Help Center | Sitemap