Specification sheets for pressure formed precision parts are full of abbreviations. This guide translates sheet gauge, cavity layout and trim tolerance into decisions you can make.
The notes below come from day to day production and export work with overseas buyers.
This category covers a family of products rather than a single item. In practice a buyer defines pressure formed precision parts by three things: the base resin, the format or dimension, and the performance or certification level it has to meet. Typical options in this category include gauge 1.0 to 6.0 mm; sharp detail and crisp radii; undercut capable tooling. Materials most often specified are Acrylonitrile Butadiene Styrene, Polycarbonate, Polyethylene Terephthalate Glycol, Polypropylene, and the choice between them changes stiffness, temperature resistance, chemical behaviour and price.
In the industrial equipment sector the decision is usually driven by thick gauge capability and flare and fire rating, with paintability as a secondary requirement. Typical end uses include twin sheet panels, protective guards, kiosk shells.
Typical values for a general purpose grade are listed below; filled, stabilised and speciality compounds will differ.
| Material | Density | Tensile strength | Service temperature |
|---|---|---|---|
| Polycarbonate | 1.20 g/cm³ | 55-70 MPa | -40°C to 120°C |
| PC/ABS Alloy | 1.13-1.15 g/cm³ | 45-60 MPa | -30°C to 110°C |
| Polypropylene | 0.90-0.91 g/cm³ | 25-40 MPa | -10°C to 100°C |
PC/ABS Alloy is frequently the default selection here: PC/ABS is the standard engineering alloy for electronics housings that must survive a drop test.
The table below summarises the values that usually decide the material choice.
When you read a supplier quotation, check that the dimension, the resin grade, the colour reference and the tolerance class are all stated. A quotation that only gives a price per piece is not comparable between suppliers.
Beyond the base resin, most suppliers offer UV stabilised, food contact, flame retardant, anti-static and recycled content versions of the same product. Ask which additive package is included, because it is often the difference between a part that lasts three years and one that lasts ten.
Processing method drives both cost and performance, so it should be fixed early in the design.
Secondary operations such as printing, welding, machining and assembly are often cheaper to do in the same factory, and they reduce the risk of mismatch between components.
Use this checklist when comparing two or three supplier quotations.
Send this list to your supplier with the drawing and you will receive comparable quotations from every factory you contact.
Yes. Standard samples are normally free of charge and shipped within three working days; custom samples are charged at cost and credited against the first production order.
Standard production tolerance follows the relevant ISO or DIN tolerance class for the process; tighter tolerances are possible after machining or grinding, but they add cost. Define the tolerance only on the functional dimensions.
A new tool typically takes 25 to 45 days depending on cavity count and complexity, followed by T1 samples within one week. Existing tools can usually start production within 10 to 15 days of order confirmation.
Colour is controlled with a masterbatch reference approved by the customer, and every production lot is checked against the approved sample under standard lighting before shipment.
Standard packing is export cartons on fumigation-free pallets, with custom labelling, barcode and retail packing available. We also handle consolidated containers and door to door delivery.
Share your specification and quantity with us and we will recommend the most cost effective material, tooling route and packing method for your market.
Rubber & Plastics © 2026 All Rights Reserved. Yingnet.com — Global B2B trade platform for rubber & plastics manufacturers.
About Us | Contact Us | Help Center | Sitemap