Correct handling and storage protect the performance of twin sheet thermoformed products from the factory to the packing line. This guide covers stacking, climate, static and inspection.
The notes below come from day to day production and export work with overseas buyers.
This category covers a family of products rather than a single item. In practice a buyer defines twin sheet thermoformed products by three things: the base resin, the format or dimension, and the performance or certification level it has to meet. Typical options in this category include integrated mounting bosses; textured both sides; gauge 2.0 to 8.0 mm. Materials most often specified are PC/ABS Alloy, Polycarbonate, Acrylonitrile Butadiene Styrene, Polypropylene, and the choice between them changes stiffness, temperature resistance, chemical behaviour and price.
In the industrial equipment sector the decision is usually driven by thick gauge capability and flare and fire rating, with paintability as a secondary requirement. Typical end uses include equipment covers, kiosk shells, machine housings.
These figures are typical for commercial grades and should be confirmed against the supplier's certificate for your specific lot.
| Material | Density | Tensile strength | Service temperature |
|---|---|---|---|
| Polypropylene | 0.90-0.91 g/cm³ | 25-40 MPa | -10°C to 100°C |
| Polycarbonate | 1.20 g/cm³ | 55-70 MPa | -40°C to 120°C |
| High Density Polyethylene | 0.94-0.97 g/cm³ | 20-32 MPa | -50°C to 80°C |
Acrylonitrile Butadiene Styrene is frequently the default selection here: ABS is the default choice when a part needs a glossy, paintable, impact-resistant surface.
Most premature failures are installation issues rather than material failures.
Keep a small stock of spares from the same production lot to avoid colour mismatch later.
Beyond the base resin, most suppliers offer UV stabilised, food contact, flame retardant, anti-static and recycled content versions of the same product. Ask which additive package is included, because it is often the difference between a part that lasts three years and one that lasts ten.
Each step below has its own control points, and skipping one of them is where most defects start.
Secondary operations such as printing, welding, machining and assembly are often cheaper to do in the same factory, and they reduce the risk of mismatch between components.
Use this checklist when comparing two or three supplier quotations.
Send this list to your supplier with the drawing and you will receive comparable quotations from every factory you contact.
Standard packing is export cartons on fumigation-free pallets, with custom labelling, barcode and retail packing available. We also handle consolidated containers and door to door delivery.
A new tool typically takes 25 to 45 days depending on cavity count and complexity, followed by T1 samples within one week. Existing tools can usually start production within 10 to 15 days of order confirmation.
We can provide ISO 9001 quality system documentation, material certificates, RoHS and REACH statements, and where applicable food contact, flame retardancy or drinking water approvals. Tell us your target market and we will match the document set.
Yes. {mat1} is one of our regular materials for this item, and we can supply virgin, modified and certified grades with full traceability. Material certificates and test reports are issued per batch.
For standard sizes and colours the minimum is usually one pallet or one production run; for custom tooling the economic minimum depends on the tooling cost amortised over the expected volume. Send us your annual volume and we will calculate the break even point.
Our team supplies twin sheet thermoformed products to industrial equipment customers worldwide, with samples, material certificates and full inspection reports available before mass production.
Rubber & Plastics-yingnet.com © 2026 All Rights Reserved. Yingnet.com style B2B marketplace template.
About Us | Contact Us | Help Center | Sitemap