In agriculture and horticulture projects, plastic rods and bars is only acceptable when the paperwork is right. This article maps the standards, test methods and documents you should ask for.
This guide is written for engineers, purchasers and project managers who need a practical answer, not a resin data sheet.
This category covers a family of products rather than a single item. In practice a buyer defines plastic rods and bars by three things: the base resin, the format or dimension, and the performance or certification level it has to meet. Typical options in this category include round, square and hex profiles; length 1000 mm and 2000 mm; ground tolerance h9. Materials most often specified are Polyvinyl Chloride, UHMWPE, Polyoxymethylene, Polytetrafluoroethylene, and the choice between them changes stiffness, temperature resistance, chemical behaviour and price.
In the agriculture and horticulture sector the decision is usually driven by UV stabilisation and tear strength, with chemical resistance to fertilisers as a secondary requirement. Typical end uses include shade nets, greenhouse film, drip irrigation lines.
These figures are typical for commercial grades and should be confirmed against the supplier's certificate for your specific lot.
| Material | Density | Tensile strength | Service temperature |
|---|---|---|---|
| Polyvinyl Chloride | 1.38-1.45 g/cm³ | 40-55 MPa | -10°C to 60°C |
| Polyoxymethylene | 1.41 g/cm³ | 60-70 MPa | -40°C to 100°C |
| Polyamide | 1.13-1.15 g/cm³ | 60-85 MPa | -40°C to 120°C |
Polyvinyl Chloride is frequently the default selection here: PVC can be formulated from rigid pipe compound to soft medical grade by changing plasticiser content.
The following standards are the ones most often referenced in this product category.
Ask the supplier to state the standard number, the test method and the result on the certificate. A test report without a standard reference is difficult to defend during an audit.
Beyond the base resin, most suppliers offer UV stabilised, food contact, flame retardant, anti-static and recycled content versions of the same product. Ask which additive package is included, because it is often the difference between a part that lasts three years and one that lasts ten.
The route below is the one most factories use for this type of part.
Secondary operations such as printing, welding, machining and assembly are often cheaper to do in the same factory, and they reduce the risk of mismatch between components.
Use this checklist when comparing two or three supplier quotations.
Send this list to your supplier with the drawing and you will receive comparable quotations from every factory you contact.
Colour is controlled with a masterbatch reference approved by the customer, and every production lot is checked against the approved sample under standard lighting before shipment.
We can provide ISO 9001 quality system documentation, material certificates, RoHS and REACH statements, and where applicable food contact, flame retardancy or drinking water approvals. Tell us your target market and we will match the document set.
Yes. {mat1} is one of our regular materials for this item, and we can supply virgin, modified and certified grades with full traceability. Material certificates and test reports are issued per batch.
Yes. Standard samples are normally free of charge and shipped within three working days; custom samples are charged at cost and credited against the first production order.
A new tool typically takes 25 to 45 days depending on cavity count and complexity, followed by T1 samples within one week. Existing tools can usually start production within 10 to 15 days of order confirmation.
If you are planning a new agriculture and horticulture project, send us your drawing, annual volume and target properties, and we will come back with a material proposal, a tooling plan and a budget quotation.
Rubber & Plastics © 2026 All Rights Reserved. Yingnet.com — Global B2B trade platform for rubber & plastics manufacturers.
About Us | Contact Us | Help Center | Sitemap