In agriculture and horticulture projects, marine and outdoor plastic products is only acceptable when the paperwork is right. This article maps the standards, test methods and documents you should ask for.
The notes below come from day to day production and export work with overseas buyers.
This category covers a family of products rather than a single item. In practice a buyer defines marine and outdoor plastic products by three things: the base resin, the format or dimension, and the performance or certification level it has to meet. Typical options in this category include buoyancy foam blocks; fender and dock profiles; UV stabilised colours. Materials most often specified are UHMWPE, Polyvinyl Chloride, High Density Polyethylene, Polycarbonate, and the choice between them changes stiffness, temperature resistance, chemical behaviour and price.
In the agriculture and horticulture sector the decision is usually driven by UV stabilisation and tear strength, with chemical resistance to fertilisers as a secondary requirement. Typical end uses include drip irrigation lines, greenhouse film, mulch film.
These figures are typical for commercial grades and should be confirmed against the supplier's certificate for your specific lot.
| Material | Density | Tensile strength | Service temperature |
|---|---|---|---|
| Polycarbonate | 1.20 g/cm³ | 55-70 MPa | -40°C to 120°C |
| UHMWPE | 0.93-0.94 g/cm³ | 30-45 MPa | -150°C to 80°C |
| Ethylene Vinyl Acetate | 0.93-0.95 g/cm³ | 10-30 MPa | -40°C to 70°C |
High Density Polyethylene is frequently the default selection here: HDPE combines toughness with chemical inertness, which is why it dominates pipe and tank markets.
The following standards are the ones most often referenced in this product category.
Ask the supplier to state the standard number, the test method and the result on the certificate. A test report without a standard reference is difficult to defend during an audit.
Beyond the base resin, most suppliers offer UV stabilised, food contact, flame retardant, anti-static and recycled content versions of the same product. Ask which additive package is included, because it is often the difference between a part that lasts three years and one that lasts ten.
The route below is the one most factories use for this type of part.
Secondary operations such as printing, welding, machining and assembly are often cheaper to do in the same factory, and they reduce the risk of mismatch between components.
These are the criteria that actually predict whether the part will perform in service.
Send this list to your supplier with the drawing and you will receive comparable quotations from every factory you contact.
For standard sizes and colours the minimum is usually one pallet or one production run; for custom tooling the economic minimum depends on the tooling cost amortised over the expected volume. Send us your annual volume and we will calculate the break even point.
A new tool typically takes 25 to 45 days depending on cavity count and complexity, followed by T1 samples within one week. Existing tools can usually start production within 10 to 15 days of order confirmation.
Yes. {mat1} is one of our regular materials for this item, and we can supply virgin, modified and certified grades with full traceability. Material certificates and test reports are issued per batch.
Standard packing is export cartons on fumigation-free pallets, with custom labelling, barcode and retail packing available. We also handle consolidated containers and door to door delivery.
Standard production tolerance follows the relevant ISO or DIN tolerance class for the process; tighter tolerances are possible after machining or grinding, but they add cost. Define the tolerance only on the functional dimensions.
If you are planning a new agriculture and horticulture project, send us your drawing, annual volume and target properties, and we will come back with a material proposal, a tooling plan and a budget quotation.
Rubber & Plastics © 2026 All Rights Reserved. Yingnet.com — Global B2B trade platform for rubber & plastics manufacturers.
About Us | Contact Us | Help Center | Sitemap