Polyoxymethylene (POM / Acetal) and Polyamide (PA6 / PA66 Nylon) are the two most quoted options for plastic fasteners, clips and cable ties in food and beverage projects. Both are widely available, but they behave very differently once they are in service.
Use it as a working checklist when you write your next enquiry.
This category covers a family of products rather than a single item. In practice a buyer defines plastic fasteners, clips and cable ties by three things: the base resin, the format or dimension, and the performance or certification level it has to meet. Typical options in this category include cable tie length 80 mm to 1200 mm; M3 to M12 screw sizes; push rivets and panel clips. Materials most often specified are Polyamide, Polyoxymethylene, Polypropylene, Polyether Ether Ketone, and the choice between them changes stiffness, temperature resistance, chemical behaviour and price.
In the food and beverage sector the decision is usually driven by food contact compliance and migration limits, with seal integrity as a secondary requirement. Typical end uses include takeaway trays, dairy tubs, shrink sleeves.
The table below summarises the values that usually decide the material choice.
| Material | Density | Tensile strength | Service temperature |
|---|---|---|---|
| Polypropylene | 0.90-0.91 g/cm³ | 25-40 MPa | -10°C to 100°C |
| Polyamide | 1.13-1.15 g/cm³ | 60-85 MPa | -40°C to 120°C |
| Polyoxymethylene | 1.41 g/cm³ | 60-70 MPa | -40°C to 100°C |
Polyoxymethylene is frequently the default selection here: POM is the standard replacement for small metal parts that must hold tight tolerances.
Polyoxymethylene grades offer excellent dimensional stability, while Polyamide brings high wear and abrasion resistance. For food and beverage service the difference shows up in chemical resistance and in the long term behaviour under load.
The practical decision usually comes down to the service environment: temperature, chemical exposure and expected lifetime.
Beyond the base resin, most suppliers offer UV stabilised, food contact, flame retardant, anti-static and recycled content versions of the same product. Ask which additive package is included, because it is often the difference between a part that lasts three years and one that lasts ten.
Processing method drives both cost and performance, so it should be fixed early in the design.
Secondary operations such as printing, welding, machining and assembly are often cheaper to do in the same factory, and they reduce the risk of mismatch between components.
Work through these points in order and most specification mistakes disappear.
Send this list to your supplier with the drawing and you will receive comparable quotations from every factory you contact.
Yes. {mat1} is one of our regular materials for this item, and we can supply virgin, modified and certified grades with full traceability. Material certificates and test reports are issued per batch.
Colour is controlled with a masterbatch reference approved by the customer, and every production lot is checked against the approved sample under standard lighting before shipment.
We can provide ISO 9001 quality system documentation, material certificates, RoHS and REACH statements, and where applicable food contact, flame retardancy or drinking water approvals. Tell us your target market and we will match the document set.
Standard packing is export cartons on fumigation-free pallets, with custom labelling, barcode and retail packing available. We also handle consolidated containers and door to door delivery.
A new tool typically takes 25 to 45 days depending on cavity count and complexity, followed by T1 samples within one week. Existing tools can usually start production within 10 to 15 days of order confirmation.
Share your specification and quantity with us and we will recommend the most cost effective material, tooling route and packing method for your market.
Rubber & Plastics © 2026 All Rights Reserved. Yingnet.com — Global B2B trade platform for rubber & plastics manufacturers.
About Us | Contact Us | Help Center | Sitemap