In home appliance projects, plastic pipes and tubes is only acceptable when the paperwork is right. This article maps the standards, test methods and documents you should ask for.
Everything here can be checked on a real sample before you commit to a production order.
This category covers a family of products rather than a single item. In practice a buyer defines plastic pipes and tubes by three things: the base resin, the format or dimension, and the performance or certification level it has to meet. Typical options in this category include OD 16 mm to 630 mm; SDR 11 / SDR 17 / SDR 26; coils and straight lengths. Materials most often specified are Polyvinyl Chloride, Polyvinylidene Fluoride, High Density Polyethylene, Polycarbonate, and the choice between them changes stiffness, temperature resistance, chemical behaviour and price.
In the home appliance sector the decision is usually driven by heat resistance and noise control, with colour consistency as a secondary requirement. Typical end uses include kettle bodies, vacuum housings, washer tubs.
The table below summarises the values that usually decide the material choice.
| Material | Density | Tensile strength | Service temperature |
|---|---|---|---|
| Polycarbonate | 1.20 g/cm³ | 55-70 MPa | -40°C to 120°C |
| High Density Polyethylene | 0.94-0.97 g/cm³ | 20-32 MPa | -50°C to 80°C |
| Polyvinyl Chloride | 1.38-1.45 g/cm³ | 40-55 MPa | -10°C to 60°C |
Polyvinyl Chloride is frequently the default selection here: PVC can be formulated from rigid pipe compound to soft medical grade by changing plasticiser content.
Ask for the certificate number and test report, not just a claim of compliance.
Ask the supplier to state the standard number, the test method and the result on the certificate. A test report without a standard reference is difficult to defend during an audit.
Beyond the base resin, most suppliers offer UV stabilised, food contact, flame retardant, anti-static and recycled content versions of the same product. Ask which additive package is included, because it is often the difference between a part that lasts three years and one that lasts ten.
The route below is the one most factories use for this type of part.
Secondary operations such as printing, welding, machining and assembly are often cheaper to do in the same factory, and they reduce the risk of mismatch between components.
Use this checklist when comparing two or three supplier quotations.
Send this list to your supplier with the drawing and you will receive comparable quotations from every factory you contact.
Yes. {mat1} is one of our regular materials for this item, and we can supply virgin, modified and certified grades with full traceability. Material certificates and test reports are issued per batch.
For standard sizes and colours the minimum is usually one pallet or one production run; for custom tooling the economic minimum depends on the tooling cost amortised over the expected volume. Send us your annual volume and we will calculate the break even point.
Yes. Standard samples are normally free of charge and shipped within three working days; custom samples are charged at cost and credited against the first production order.
Colour is controlled with a masterbatch reference approved by the customer, and every production lot is checked against the approved sample under standard lighting before shipment.
Standard packing is export cartons on fumigation-free pallets, with custom labelling, barcode and retail packing available. We also handle consolidated containers and door to door delivery.
If you are planning a new home appliance project, send us your drawing, annual volume and target properties, and we will come back with a material proposal, a tooling plan and a budget quotation.
Rubber & Plastics © 2026 All Rights Reserved. Yingnet.com — Global B2B trade platform for rubber & plastics manufacturers.
About Us | Contact Us | Help Center | Sitemap