If you specify PC/ABS Alloy for thick gauge thermoformed machine housings, a handful of properties decide whether the part survives forming and service. These are the values worth checking on every data sheet.
Use it as a working checklist when you write your next enquiry.
This category covers a family of products rather than a single item. In practice a buyer defines thick gauge thermoformed machine housings by three things: the base resin, the format or dimension, and the performance or certification level it has to meet. Typical options in this category include textured and glossy surfaces; class A painted finishes; gauge 2.0 to 10.0 mm. Materials most often specified are Polycarbonate, PC/ABS Alloy, Polypropylene, Acrylonitrile Butadiene Styrene, and the choice between them changes stiffness, temperature resistance, chemical behaviour and price.
In the home appliance sector the decision is usually driven by deep draw capability and chemical resistance to insulation foam, with surface quality as a secondary requirement. Typical end uses include refrigerator liners, machine covers, control panel surrounds.
The table below summarises the values that usually decide the material choice.
| Material | Density | Tensile strength | Service temperature |
|---|---|---|---|
| Acrylonitrile Butadiene Styrene | 1.04-1.06 g/cm³ | 30-50 MPa | -20°C to 80°C |
| High Density Polyethylene | 0.94-0.97 g/cm³ | 20-32 MPa | -50°C to 80°C |
| Polycarbonate | 1.20 g/cm³ | 55-70 MPa | -40°C to 120°C |
PC/ABS Alloy is frequently the default selection here: PC/ABS is the standard engineering alloy for electronics housings that must survive a drop test.
The table below summarises the values that usually decide the material choice.
Density 1.13-1.15 g/cm³, tensile strength 45-60 MPa, continuous service temperature -30°C to 110°C and melt range 240-270°C are the four values to circle on the data sheet. Everything else is secondary for most home appliance projects.
Beyond the base resin, most suppliers offer UV stabilised, food contact, flame retardant, anti-static and recycled content versions of the same product. Ask which additive package is included, because it is often the difference between a part that lasts three years and one that lasts ten.
The route below is the one most factories use for this type of part.
Secondary operations such as printing, welding, machining and assembly are often cheaper to do in the same factory, and they reduce the risk of mismatch between components.
Work through these points in order and most specification mistakes disappear.
Send this list to your supplier with the drawing and you will receive comparable quotations from every factory you contact.
Standard packing is export cartons on fumigation-free pallets, with custom labelling, barcode and retail packing available. We also handle consolidated containers and door to door delivery.
A new tool typically takes 25 to 45 days depending on cavity count and complexity, followed by T1 samples within one week. Existing tools can usually start production within 10 to 15 days of order confirmation.
Yes. Standard samples are normally free of charge and shipped within three working days; custom samples are charged at cost and credited against the first production order.
Colour is controlled with a masterbatch reference approved by the customer, and every production lot is checked against the approved sample under standard lighting before shipment.
Standard production tolerance follows the relevant ISO or DIN tolerance class for the process; tighter tolerances are possible after machining or grinding, but they add cost. Define the tolerance only on the functional dimensions.
Our team supplies thick gauge thermoformed machine housings to home appliance customers worldwide, with samples, material certificates and full inspection reports available before mass production.
Rubber & Plastics © 2026 All Rights Reserved. Yingnet.com — Global B2B trade platform for rubber & plastics manufacturers.
About Us | Contact Us | Help Center | Sitemap