Correct handling and storage protect the performance of thick gauge thermoformed machine housings from the factory to the packing line. This guide covers stacking, climate, static and inspection.
Everything here can be checked on a real sample before you commit to a production order.
This category covers a family of products rather than a single item. In practice a buyer defines thick gauge thermoformed machine housings by three things: the base resin, the format or dimension, and the performance or certification level it has to meet. Typical options in this category include textured and glossy surfaces; moulded in colour and post painted; gauge 2.0 to 10.0 mm. Materials most often specified are High Density Polyethylene, Polypropylene, Polycarbonate, PC/ABS Alloy, and the choice between them changes stiffness, temperature resistance, chemical behaviour and price.
In the medical and pharmaceutical sector the decision is usually driven by validated sealing and sterilisation compatibility, with traceability as a secondary requirement. Typical end uses include diagnostic packs, pharmaceutical blisters, IV and catheter kits.
These figures are typical for commercial grades and should be confirmed against the supplier's certificate for your specific lot.
| Material | Density | Tensile strength | Service temperature |
|---|---|---|---|
| High Density Polyethylene | 0.94-0.97 g/cm³ | 20-32 MPa | -50°C to 80°C |
| Acrylonitrile Butadiene Styrene | 1.04-1.06 g/cm³ | 30-50 MPa | -20°C to 80°C |
| Polypropylene | 0.90-0.91 g/cm³ | 25-40 MPa | -10°C to 100°C |
Polycarbonate is frequently the default selection here: PC replaces glass where impact safety matters, but it needs a hard coat for abrasion resistance.
Most premature failures are installation issues rather than material failures.
Keep a small stock of spares from the same production lot to avoid colour mismatch later.
Beyond the base resin, most suppliers offer UV stabilised, food contact, flame retardant, anti-static and recycled content versions of the same product. Ask which additive package is included, because it is often the difference between a part that lasts three years and one that lasts ten.
The route below is the one most factories use for this type of part.
Secondary operations such as printing, welding, machining and assembly are often cheaper to do in the same factory, and they reduce the risk of mismatch between components.
Work through these points in order and most specification mistakes disappear.
Send this list to your supplier with the drawing and you will receive comparable quotations from every factory you contact.
Yes. {mat1} is one of our regular materials for this item, and we can supply virgin, modified and certified grades with full traceability. Material certificates and test reports are issued per batch.
Yes. Standard samples are normally free of charge and shipped within three working days; custom samples are charged at cost and credited against the first production order.
A new tool typically takes 25 to 45 days depending on cavity count and complexity, followed by T1 samples within one week. Existing tools can usually start production within 10 to 15 days of order confirmation.
Standard packing is export cartons on fumigation-free pallets, with custom labelling, barcode and retail packing available. We also handle consolidated containers and door to door delivery.
Colour is controlled with a masterbatch reference approved by the customer, and every production lot is checked against the approved sample under standard lighting before shipment.
If you are planning a new medical and pharmaceutical project, send us your drawing, annual volume and target properties, and we will come back with a material proposal, a tooling plan and a budget quotation.
Rubber & Plastics © 2026 All Rights Reserved. Yingnet.com — Global B2B trade platform for rubber & plastics manufacturers.
About Us | Contact Us | Help Center | Sitemap